pixma pro 100s 15 flashes, all lights on

[nickyk13]

Hi all. Once again trying to do a little printing. After refilling a few empthy tanks I'm surprisingly greeted by 15 flashing lights. So clearly one of the tanks isn't recongized (so I thought). Sure enough GY wasn't illumnated red. So I replaced it with a brand new, never used, GY and it lit right up. But I'm still getting 15 yellow flashes. All the red lights are absolutely on. I have tried turning the whole thing off and on again to see if clearing the memory, if that's a thing, would work. It does not. Any thoughts on how to clear this problem? It says it's offline and will not print. Thank you!

 

[jimbo123]

try resetting all the carts.

make sure you get a good solid reset light. my resetter takes a while to reset while pressing down firly

J

------------------------------------------------------------------------------
• Active Printers: MX700(2007), MP980(2008), MX870(2010), PRO-100(2013)
• Stored Printers: IP4500, MX700, MX860, MX870, MP980
• Past Printers: MP830
• Method: German Durchstich Method
• Ink: Hobbicolors, then OCP, now ASPEN
• Misc: Squeeze bottles - so much easier than syringes

 

[nickyk13]

Thanks Jimbo. My resetter just flashes, never gives me a solid light but I'll redo all of that.

 

[The Hat]

Thanks Jimbo. My resetter just flashes, never gives me a solid light but I'll redo all of that.

Try Replacing the battery then try the reset again..
If necessary rest all the carts from start..