Lelopes
Getting Fingers Dirty
- Joined
- Sep 28, 2021
- Messages
- 31
- Reaction score
- 37
- Points
- 48
- Printer Model
- Canon IX6810
No worries, this thread appeared on front page as recommendation and I got curious, that's all.Sorry about that, but @Nifty did start this thread off here and who’s going to argue with him, maybe it’s a reminder for you to dust off your Auld 3D printer and get going on something new..
I believe my 3d printer is beyond hope now. I assembled it as a Graber (prusa like, but using laser cutted MDF) after some time one of my axis wasn't responding. Ichecked the motor, replaced the drivers, reflashed firmware, replaced the Arduino Mega, replaced shields ramps 1.4, at this point I got really frustrated since I was already unhappy with print bed size been too small. Everything was working separately, but failed when putting it together. By now, It got a lot of rusty on it too, so I don't believe it is good for anything other than scrap right now. This is like a divorce story, the printer failed me multiple times, till I failed her and we broke apart.
Last edited: