Salvaging long unused Pixma Pro 100

[PeterBJ]

I think the problem is caused by a dirty, bent or broken contact spring for the cyan chip. The CLI-42 cartridges are physically identical to the old CLI-8 cartridges, so see this post about a similar problem.

 

[jimbo123]

try resetting it a few times, that sometimes works for me.

there is a lot of 8 empty CLI-42 carts w chips on ebay for $9.99 shipped
https://www.ebay.com/itm/163428329938

a new CLI_42 CYAN is $16 on amazon
https://www.amazon.com/Canon-CLI-42-PC-Photo-Cyan/dp/B0098HW3DI?th=1

J

------------------------------------------------------------------------------
• Active Printers: MX700(2007), MP980(2008), MX870(2010), PRO-100(2013)
• Stored Printers: IP4500, MX700, MX860, MX870, MP980
• Past Printers: MP830
• Method: German Durchstich Method
• Ink: Hobbicolors, then OCP, now ASPEN
• Misc: Squeeze bottles - so much easier than syringes

 

[PeterBJ]

Moving the good print head to the other printer might give you a working printer, but it might also ruin the good print head.

When a Canon print head fails there is a risk that it damages the main board. A main board damaged by a print head might damage a new print head.

In many Canon service manuals it is recommended that both the print head and main board are replaced in case of a defective print head.