- Thread starter
- #31
- Joined
- Nov 3, 2004
- Messages
- 3,066
- Reaction score
- 1,430
- Points
- 337
- Location
- Bay Area CA
- Printer Model
- CR-10, i560 ,MFC-7440N
250,000... but it was working fine for the first few prints, then since rebooting, it started working fine for subsequent prints. I'll keep testing it, but for now, any print longer than 2 hours will definitely be going on the SD card to be safeWhat baud rate are your running at? Try dropping it to see if it improves (prob best not to go above 57600).
Interesting... I didn't know that was an option. I'll give that a test for sure, thanks!Have you tried using Pronterface to uploaded your gcode to the sdcard in the printer?