DIY Eco Tank bottles?

[LindaClary]

I replaced an Epson printer that used 502 bottles with one that uses 552 bottles of ink. I would like to use the ink I already purchased (the 502 bottles) and eventually refill the 552 bottles myself. (Use Epson ink purchased in bulk.) Is there a way to do this? I tried twisting the top of the 552 bottles - to no avail. Any ideas are so appreciated. TY.

 

[pharmacist]

Use a syringe to suck out the ink from the bottle and inject it directly into your printer in the corresponding colour.

 

[LindaClary]

Great idea. Then tape over the puncture. Thank you.

 

[The Hat]

Great idea. Then tape over the puncture. Thank you.

Use a syringe to suck out the ink from the bottle and inject it directly into your printer in the corresponding colour.

I reckon you may have to be a little bit more specific..

 

[pharmacist]

I reckon you may have to be a little bit more specific..

Inject the ink in the corresponding ink tank of your ecotank printer, so do not inject magenta in the yellow tank

 

[bplaman]

Simple advice. Sell 502 and buy 552. And the issue is resolved without any problems (punctures, tapes, holes, profiles, etc.)

 

[Ink stained Fingers]

I have not seen any bottle for the Ecotank printers - 102, 106, 114, 664 and more - on which you could not unscrew the top of the bottle - it's pretty tight and you might have to use a tool. Give it another try.