3D Print Christmas lamps

[The Hat]

But if you do go elbows up over your fairy lights and lamppost, I call dibs on your printers.

Your welcome to take them back with you after the wake…

 

[stratman]

the wake

Oh the stories that will be told.

Will there be alcoholic beverages involved?


PS I'll make sure you're buried with your beloved 3D Printer and a bottle of Southern Comfort. Even Heaven (wherever) will need a toilet paper roll holder replaced during eternity and you a tipple while it's printing.

 

[The Hat]

I needed end pieces for my fence, (Not yet erected) and was in the middle of designing a cone or spear type piece when @Nifty posted this video from Clive.

There was a small gap in the bad weather so I managed to get my fence up despite it raining most of the time.. Just..

I also got the extra roll of gold filament that I was waiting on and printed another 5 new spikes for the fence top all in gold, I then sprayed them with a satin clear lacquer for UV protection, and hopefully that will help them last a bit longer.
I needed an oil filter clamp tool with a leather strap to pull the ends of the upright bars together and the spikes then fitted over the top like a glove..
click to enlarge..

There’s a lot more work needed to sort out the bottom of the fence, but it will have to wait till we have solid ground again, right now everything is floating in mud..

 

[stratman]

Looking good, my friend!

Is that a bit of the sea on the left hand side of the image?

PS Nice Ted-proofing below the auld wooden fence.

 

[The Hat]

Is that a bit of the sea on the left hand side of the image?

PS Nice Ted-proofing below the auld wooden fence.

Yes that’s sea, and no Ted won’t get through, it’s metal..
And he can’t climb over it either..

 

[stratman]

Yes that’s sea

House on the water? I knew you were posh!