Search results

Thank you @annel and @The Hat for the nice words.. cheers Leonard

Cartridge not recognized is the normal message when it is time to reset..Power off then power on. If that does work make sure chip contacts are clean and making a good physical connection. If you want a chip replacement send me a photo of the cartridge with the chip off..We used thru the years...

Thank you, Hat

Well I am glad it worked out...What an adventure .... The 676xl cartridge in the wf 4530/4540 uses the same Durabrite Ultra pigment as the 786 cartridge in the 4630... (your ink will work) We have held off adding the 4630 because of the lack of a reliable resettable chip, until now.... So the...

Plugs are on the way.... Leonard

Hi there, did you get the issue resolved with the printer...

Hi Tim Pleasure talking to you yesterday. I hope the information we went over was helpful. Thanks Hat! for the referral... Cheers LJH

Congratulations Hat, You have always been a great supporter Leonard

Thank you LJH

Thank you Leonard

Thank you Ann cheers LJH

Thank you Hat Leonard

Hi Jeff If you punctured the service plug and your ciss is below your cartridge height you could induce air to your system.. If your poppet valve is not making a good seal at the cap assembly you could induce air to your system.. I can send you a replacement black ciss cartridge at no...

Hi shpitz Did you buy the tank from us "LJH" I will replace it at no charge... Our tanks are repairable, tank comes out from case and seals/elbows and tubing can be replaced

Great to hear!!! LJH

I know what you mean, I have a HP 7600, real work horse of a printer...30k+ prints I am sad to say.... off to the electronic recycler.. Print heads are more than a new printer I replaced our Artisans with WF 4630 big refillable cartridges(invoice/label printing) and a 1430 for cd and 13x19...

Hi jfcarbel Continuous ink supply systems are nothing more than a large ink cartridge.If you have ink in the the cartridge it has done its job... In the rare instance that the air breather caps are on the tanks or the tank is to low or the ink tubes are constricted...then the ciss will fail to...

Hi Anne and Hat Sending you a double sided nipple (splice connector), ink tube with cartridge elbow and seal. First remove the excess plastic or sharp edge on the printer's lid that caused the problem. Attach nipple to each end of the splice (outside of printer), attach cartridge elbow, route...

Thank you, Hat Leonard