Search results

I wonder how many pages printed on it? The problem seems to be carriage or liner rail defect, when printhead stops to change motion due to slack it makes double image. Seems you better sell this cheap as repair can be very expensive and result is not guaranteed. If you can get second printer...

This is electronic failure of print cartridge, you can only replace it. :(

I bought some carts from china for my old LaserJet 6L, has similar problem, I had to replace the wiper blade and toner roller from known good cart.

Make sure you double check connectors on ribbon cables, as these can fail. There is a post on this forum https://www.printerknowledge.com/threads/epson-sc-p600-error-0x44-after-printhead-removal-and-cleaning.16095/

Software protection can fail, this video demonstrates this:

"$9999 is a virtual price so that you can add S1/T1 to your shopping cart and receive notification of availability as soon as possible." The printer cost is 1399Eur https://www.3djake.de/flsun/s1

Hard to say what part is bad, but it's the cartridge problem. Bad wiper blade i would say or bad doctor blade

Hello, Thermal fuse in your printer can prevent fire hazard. Somehow I do not see these mentioned / tested by paid influencers that I would not give anything to test due to their stupidity in the first place. There are fuses available up to 300C so should be perfect even if you use engineering...

Make a simple test, reset printer to default, then place document of scanner make a copy with same settings like you use for printing, draft/normal etc. If the printer works fine but when connected to PC does not, the problem is not the printer but the computer.

I needed to fix clients R3000, no parts available. :(

Well at least you can calibrate deltas with klipper, unlike corexy it is not possible to calibrate it. Like at all, because 2 motors are used for single axis.

Hello, Found this video while looking for enclosures for 3D printers. A guy discovered that all his house is covered with PLA dust, cant be good for you health right. And most PLA printers are not enclosed right.

T1 is also nice but they have round print beds so S1 print bet allows to print 22x22cm square objects, T1 don't know see https://www.omnicalculator.com/math/square-in-a-circle to calculate that. T1 is very limited then.

If bambulab P1S or X1C would not use carbon rods as they marketing campaign, would not have problem with ghosting from 100 to 200 mm/s then that would be a contender, however due to lower printing speeds for non PLA technical plastics makes bambulab P1S or X1C unusable. Also keep in mind that...

I'm waiting for FLSUN S1 to be reviewed, this is really going to be a gamechanger.

I thought for 1500eur you would get better support then "add packing tape" but nda agreements make sure those reviews on youtube are not telling the truth. 75000 printers sold? Then where are non influencer videos on youtube about them, youtube would be flooded. I remember i looked at smartphone...

This video shows bambulab X1C print head wobble after 2 months?

I can say I have not seem any videos printing technical parts on X1C either, only toys, nonsense type of prints. No measurements with dial indicator, digital caliper, printing calibration parts either. The carbon rods are mystery to me also. They run supposedly dry, but what bushing do they...

Here is a Vonron trident frame problems in this video: Link to printer in review...

The Bambulab LIDAR is not working? You can read here: Is LiDAR a gimmick? https://forum.bambulab.com/t/is-lidar-a-gimmick/578?page=2